[RocketsNW] Fins on a Minimum Diameter

[Christopher Guenther]

Personally I take the table cloth off the table and set it aside.  Then
cover the table with Freezer Paper and tape it down so I do not get any
epoxy drips onto that beautiful wood finish I paid so much for.  That is
where I have built all my rockets.  My wife knows I use the table and the
oven but yes I always make sure she is out of the house when I do it, she
used to complain about the smells I was making with the epoxies and
paints(not the air).

Chris Guenther
NAR L2



On Wed, Feb 3, 2010 at 1:07 PM, <Mfreptiles at aol.com> wrote:

> I know that clean/smooth PVC pipe does not adhere to JB Weld.  A few  taps
> with a hammer releases cleanly.
>
> Mike F.
>
>
> In a message dated 2/3/2010 12:22:48 P.M. Pacific Standard Time,
> jman13 at gmail.com writes:
>
> Should I  worry about PVC adhering to epoxy? How about  JB
> Weld?
>
> _______________________________________________
> Rockets mailing list
> Rockets at rocketsnw.com
> http://mx1.blastzone.com/mailman/listinfo/rockets
>
>